7
TOOL SET-UP
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool,
and release the trigger before performing any inspection, maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. Improper adjustment can result in tool failure or other serious hazards.
TO PREVENT SERIOUS INJURY:
DO NOT USE GRINDING DISCS, GRINDING WHEELS, OR CUT-OFF WHEELS WITH THIS
TOOL. This tool has no safety shield.
TO PREVENT SERIOUS INJURY:
All accessories must be
1. Insert the Spindle Lock Pin (24) into the
hole on the Spindle Ring (21).
See Figure A.
2. Place the desired Pad (22a/b/c)
onto the Spindle Ring. Apply a
sandpaper disc of the same size
to the Pad with the rough side
facing away from the Pad.
3. Secure Pad in place with the Arbor
Nut (23).
4. Remove the Spindle Lock Pin
before use.
Figure A: Installing the Pad
WORK AREA SET-UP
1. Designate a work area that is clean and well-lit. The work area must not allow access
by children or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach the work area without creating a tripping
hazard or exposing the air hose to possible damage. The air hose must be long enough
to reach the work area with enough extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps (not included) to prevent movement
while working.
4. There must not be hazardous objects (such as utility lines or foreign objects) nearby
that will present a hazard while working.
General Operating Instructions
1. If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops more after each hour of continual use.
2. Squeeze the Trigger and allow the tool to come up to full speed.
3. The tool’s speed can be adjusted by turning the Air Regulator.
