6
4. Close the in-line shut-off valve between the compressor and the tool.
5. Turn on the air compressor according to the manufacturer s directions and allow it to
build up pressure until it cycles off.
6. Adjust the air compressor s output regulator so that the air output is enough to properly
power the tool, but the output will not exceed the tool s maximum air pressure at any time.
Adjust the pressure gradually, while checking the air output gauge to set the right pressure
range.
7. Inspect the air connections for leaks. Repair any leaks found.
8. If the tool will not be used at this time, turn off and detach the air supply, safely
discharge any residual air pressure, and release the trigger to prevent accidental
operation.
Note: Residual air pressure should not be present after the tool is disconnected from the
air supply. However, it is a good safety measure to attempt to discharge the tool in a safe
fashion after disconnecting to ensure that the tool is disconnected and not powered.
WARNING: Read the ENTIRE important operating instructions before set-up or use of this
product.Inspect tool before use, looking for damaged, loose, and missing parts. If any problems
are found, do not use the tool until it has been repaired.
