warnings, instructions, illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below may result inelectric
shock, fire and/or serious injury.
b)
Operations such as sanding, wire brushing, polishing or cutting-off are
not recommended to be performed with this power tool. Operations for which
thepower tool was not designed may create a hazard and cause personal injury.
c)
Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can be
attached to your power tool, itdoes not assure safe operation.
d)
The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. Accessories running faster than their rated
speed can break and fly apart.
e)
The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot be
adequatelyguarded or controlled.
f)
Threaded mounting of accessories must match the grinder spindle thread.
For accessories mounted by flanges, the arbour hole of the accessory must
fit the locating diameter of the flange. Accessories that do not match the
mounting hardware of
the power tool will run out of balance, vibrate excessively and
may cause loss of control.
g)
Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear
or excess wear. If power tool or accessory is dropped, inspect for damage
or install an undamaged accessory. After inspecting and installing an
accessory, position yourself and bystanders away from the plane of the
rotating accessory and run the power tool at maximum no-load speed for
one minute. Damaged accessories will normally break apart during this test time.
h)
Wear personal protective equipment. Depending on application, use face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection must be capable of
stopping flying debrisgenerated by various operations. The dust mask or
respirator must be capable of filtrating particles generated by your operation.
Prolonged exposure to high intensity noise may cause hearing loss.
