Neilsen CT0079, Original Instruction, Page: 10 / 13

9
4. ALWAYS finish tightening with a torque wrench or suitable spanner. The
weight of the vehicle will need to be placed on the wheel to prevent it
from rotating while the nuts are tightened. Ensure the final torque applied
to the nuts meets the vehicle manufacturer’s recommendations
12.MAINTENANCE
CLEANING
1. Always inspect the tool before use and ensure it is in top condition.
2. Ensure all air vents are clear, (use compressed air to clean the
machine if possible).
GENERAL MAINTENANCE
1. Ensure all nuts, bolts and screws remain tight to ensure the machine
is in safe working condition.
2. Refer to your dealer if internal maintenance is required.
3. Check the power cable to ensure it is sound and free from cracks,
bare wires etc. Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from the various types of
commercial solvents.
• All bearings etc, in this tool are lubricated with a sufficient amount
of high grade lubricant for the tools lifetime under normal
operating conditions, therefore no further lubrication is required
REPLACING THE CARBON BRUSHES
1. Remove and inspect the carbon
brushes after periods of extended
use.
2. Replace them when they
eventually wear down.
• The brushes should be kept
clean and free to slide up and
down in the holders. Both
brushes should be replaced at