Please note:
A wall hanging set can be
obtained from your dealer (see section
on special accessories in the instruction
manual) for fastening the hood (e.g. at
the end of the row of kitchen units).
The extractor hood
is designed for
installation between two wall cabinets.
1.
Remove grease filter (see instruction
manual).
2.
Using the enclosed template mark
the positions of the screws on the
side panels of the neighbouring
cabinets, Fig. 8.
The extractor hood can also be
installed slightly lower, depending on
the height of the wall cupboards.
Position the template correspondingly
lower.
Observe the minimum distance
from hob to extractor hood of
650 mm
(the fixing screws must be fitted at least
1040 mm above the hob).
3.
Predrill (with bradawl or 2 mm bit)
and screw in the screws to 5 mm,
Fig. 9.
4.
Suspend the extractor hood on the
two screws between the wall
cabinets, Fig. 10.
5.
The two door carriers of the extractor
flap must be pushed into the
appliance to the stops, Fig. 11.
6.
Align the extractor hood with the
leading edge of the side cabinets.
Important:
If the door of the unit is at
a distance from the body of the unit
(e.g. due to rubber stops), the
extractor hood must be drawn
forward by the same distance.
Mark the position of the lower fixing
screws, predrill and fasten the
screws.
All four fixing screws must be firmly
tightened. Fig. 12.
7.
Connect pipes.
8.
Connect electricity.
Mounting the door:
Door thickness: min. 16 mm
Door height: 380 to 700 mm
Door weight: max. 7 kg.
In order to match the wall cabinets on
either side, the door can project at the
top and bottom. Fig. 13.
1.
Remove the two door carriers to the
right and left, by pulling both the red
plastic catches inwards and removing
the door carrier out towards you.
Fig. 14.
2.
Mark the fixing points on the door.
For dimensions of vertical screw
fixings, see Fig. 15.
If the top edge of the door is not
flush with the top edge of the cabinet,
amend the dimensions accordingly.
If the tops of the cabinets are
not installed flush with each other,
the door must be mounted corre-
spondingly higher.
The screw locations on the door can
be marked directly on the door in
situ. If you are doing this, leave the
door carriers in the appliance.
Position the door, align it and mark
the back.
Keep precisely to the dimension
570 ± 2.
3.
Screw the door carriers to the door,
making sure your left-right orientation
is correct. Fig. 16.
4.
Insert the complete door into the
extractor hood. Fig. 11.
Check that the door meets the
stops on both sides when pulled out.
This means that it is safely locked in
place.
The red plastic catches can only be
released if the door is not swung out to
the stop.
5.
The two screws to the right and left
inside the housing can be used to
adjust door gliding according to the
weight of the door. Fig. 17.
❑
Turning the screws clockwise will make
the door more difficult to move..
Installation
5
5750.175 652-en 16.11.2006 9:35 Uhr Seite 5
