2
Important
Installation of the
extractor hood
at
a minimum distance of
650 mm (
Fig. 1)
is only permissible above a gas hob if
the following rated heat loads (Hs) are
not exceeded:
❑
Gas cookers
load on one burner max.
0
3.0 kW
load on all burners max.
0
8.3 kW
load on oven max.
0
3.9 kW
❑
Gas hobs
load on one burner max.
0
3.9 kW
load on all burners max. 11.3 kW
❑
Gas glass-ceramic hotplate
The data on nominal heat loads do
not apply to gas glass-ceramic hot-
plates. Be sure to observe the
instructions provided by the manu-
facturer of the hotplate.
❑
Solid-fuel cookers
The maximum nominal heat loads
and the minimum distance are the
same as for gas cookers.
Installation of the extractor hood is
only permissible over a solid fuel stove
(which may constitute a fire hazard, e.g.
from sparks), provided the solid-fuel
stove has an enclosed, non-removable
cover and national regulations are com-
plied with. This restriction does not
apply to gas cookers and gas hobs.
The closer the extractor hood is to
the hob, the greater the possibility that
rising steam will condense into drops
below the extractor hood.
Before reading
this manual, please
unfold the illustrations at the back.
Old appliances still have some resi-
dual value. An environment-friendly
method of disposal will ensure that
valuable raw materials can be recovered
and used again.
Before you dispose of your old applian-
ce, make sure that it has been rendered
inoperable.
Your new appliance was protected
by suitable packaging while it was on its
way to you. All materials used for this
purpose are environment-friendly and
suitable for recycling. Please make a
contribution to protecting the environ-
ment by disposing of the packaging
appropriately.
Up-to-date information concerning opti-
ons for disposing of your old appliance
and the packaging from the new one
can be obtained from your retailer or
local government office.
The extractor hood can be used for
both exhaust (vented) and recirculation
(ventless) operation.
Always position the extractor hood
over the middle of the hob.
The minimum distance between the
hob and the lower edge of the extractor
hood is
650 mm,
Fig. 1.
Additional directions concerning gas
cookers:
Current installation specifications and
directives of the gas appliance manufac-
turers must be complied with.
Only one side of the extractor hood
should be next to a full-height cabinet
or a wall. Minimum distance: 50 mm.
5750.175 652-en 16.11.2006 9:35 Uhr Seite 2
