NEFF B45M42NOGB, Instruction Manual

Page: 17 / 20

17
Fitting the door panel
1.
Insert the door panel into the two supports (Fig. A).
2.
Press on the door panel on the left and right next to the
holders until it engages in the holders (Fig. B).
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
ã=
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
$ %
$
%
$ %
D
D
& '
Problem Possible cause Remedial action
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Fuse defective Check fuses in the fuse box and replace if
necessary
Liquid or thin dough runs to one side Appliance not installed level Check the appliance installation (see the
Installation instructions)
‹
:
‹‹
flashes in the clock display There was a power cut Reset the clock (see section: Electronic
clock)
Electronically controlled functions are
malfunctioning
Energy surges (e.g. lightning strike) Reset the function concerned
Smoke is generated during roasting or
grilling
Fat is burning on the grill element Continue grilling or roasting until the fat on
the grill element is burnt away
Wire rack or universal pan inserted
incorrectly
Place the wire rack in the universal pan
and insert them together at a lower shelf
height
High levels of condensation are generated
in the cooking compartment
Normal occurrence (e.g. when baking with
very moist toppings or roasting a large
joint)
Open the appliance door briefly from time
to time during operation