NEFF B14P42.5GB, Instruction Manual

Page: 25 / 32

25
Removal
1.
Detach the oven door and lay it on a cloth with the handle
facing down.
2.
Unscrew the cover at the top of the oven door. To do this,
unscrew the left and right screws (fig. A).
3.
Lift the top panel up and pull it out and remove the two small
seals (fig. B).
4.
Unscrew the retaining clips on the right and left. Lift the panel
and remove the clips from the panel (fig. C).
5.
Remove the seal from the bottom of the panel (fig. D). Pull
the seal and remove it up and out. Pull out the panel.
6.
Pull the lower panel at an angle, upwards and out.
7.
Do NOT unscrew the left and right-hand screws from the
sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
1.
Insert the lower panel at an angle towards the back (fig. A).
2.
Slide in the middle panel (fig. B).
3.
Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
4.
Hook the seal in to the bottom of the panel again (fig. D).
5.
Insert the uppermost panel at an angle to the back into the
brackets. Take care not to push the seal to the back (fig. E).
6.
Insert the two small seals on the left and right of the panel
again (fig. F).
7.
Put the cover back in place and screw it on.
8.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
% $
' &
(
% $
' &
) (