5
Installation
Neets Sound Bar – SB2 is designed to be easily installed, in any convenient location. It can be mounted on the
wall beneath, or above a screen, or placed on a desk free standing.
To use the Sound Bar freestanding on a desk, simply unpack the unit, mount the adhesive feet, and it is ready
to go.
To use the Sound Bar on a wall use the included brackets, screws and when necessary wall plugs. Unpack the unit,
make the measurements on the wall and place the unit on the surface where it should be mounted.
It is recommended to connect the power and audio cables to the Sound Bar before mounting on the
wall.
50 mm
750 mm
50 mm
Center Line
Included in the box is a template for easy mounting. Use a level to ensure the template is in level, and then tape the
template securely to the wall. Use an awl or other sharp object to punch 4 small holes through 4 of the marked
locations on the template.
Remove the template from the wall and drill pilot holes. Pre-drilling is optional, however it will result in a more
accurate installation.
Insert and secure the wall anchors.
If drilling into wood stud, do not use the wall anchors.
If drilling into Sheetrock, screw the wall anchors into the drywall with a Phillips head screwdriver until the head is flat
against the wall surface. Be careful not to overtighten.
Fasten the Sound Bar brackets to the wall, using the screws supplied in the wall mount kit. Use a level to verify
accuracy a final time, and then tighten the screws securely.
Then screw the four thumb screws included in the box into the Sound Bar.
See drawing for correct placement.
Hang the Neets Sound Bar securely on the two (2) brackets and adjust the
two thumb screws (marked on the drawing for correct spacing to the wall.
For mounting the Sound Bar to a cart, use the VESA 400 or 800 holes at the rear of the Sound Bar.
