12
Commands or queries send to the Sound Bar
Commands or queries to the Sound Bar is always structured the same way:
Replies from the Sound Bar
The Sound Bar will reply with an acknowledgement to a command to indicate that the command
have been accepted
Reply
on
accepted
command:
NEUNIT=1,OK\CR
If a query is sent to the Sound Bar the reply will be equal to the query with the question mark
replaced by the actual string or value matching the query:
Reply
to
a
query:
NEUNIT=1,POWER=ON\CR
If the Sound Bar detects an error in the command or query received, the Sound Bar will reply with
the following reply indicating an error.
Reply
on
errors:
NEUNIT=1,ERR\CR
If the Sound Bar is set to Auto On/off mode by switch on back panel and there is an incom- ing
command, the Sound Bar will reply with the following indicating an error.
Reply
when
set
in
Auto
On/off
mode:
NEUNIT=1,ERR_MODE_SWITCH_IN_AUTO\CR
All RS-232 communications is case sensitive.
It is possible to send multiple commands without time delay between commands by delimiting each
command with the command ending \CR.
When adjusting any settings using RS-232 commands the changes will automatically be saved in the Sound Bar.
The saved settings will be used as default values next time power is connected to the Sound Bar. This function could
be used to change the volume in “Auto On/off” mode.
