•
Šaldova 12
•
Prague 8
•
168 00
•
Czech Republic
•
Europe
•
You do not need to fill anything in.
•
You can also check the last position and unit communication, as well as the current battery status in module settings.
USB AND LED
A micro USB connector and LED signalling charging status is located under a rubber cover on the front side. The USB connector is used for charging M, L and S series modules.
The Trexee L Solar version requires charging with direct solar light. Charging the unit fully takes 65 to 75 hours, depending on the solar activity.
Charging times when using original accessories for charging
•
L series
–
typically 10 to 12 hours
•
M series
–
typically 5 to 7 hours
•
S series
–
typically 2 to 3 hours
LED SIGNALLING
Green LED
–
power supply, accumulator charging
Flashing
Accumulator charging in progress
Solid light
Accumulator is fully charged, power supply connected
Switched off
Sleep mode
Yellow LED
–
GSM status
Flashing with 0.5 s interval
Not logged in to GSM, no SIM card
Flashing with 1 s interval
Logged in to GSM
DETECTION OF REMOVAL
After the Maxi or Standard module has been installed on the tracked item (a railway carriage, container, vehicle), module position can be locked. If the module is
subsequently removed from the item, an alarm is triggered. See the LOCK setting above. Notification must be created for obtaining notices to your mobile phone.
See the TREXEE system manual.
RECORD OF ANALOGUE VALUES
The modules allow measuring and recording internal analogue values (temperature, humidity, atmospheric pressure, battery voltage, battery capacity) at a regular
set interval. This interval may be set within the range from 1 to 240 minutes. Measuring or recording analogue values does not wake the GSM or GPS module.
Saved values are sent once the module is fully awakened according to the selected profile.
