19
EN Operating Instructions
Adjust the laser beam
Button/ Symbol
Description
Use the RIGHT/LEFT arrow buttons to
swing the laser beam to the side. To do
so, press the button briefly or keep it
pressed.
The top part of the display shows the
laser beam‘s current position.
Reset the laser beam
Button / Symbol
Description
The laser beam can be reset to the mid-
dle by pressing the RIGHT/LEFT arrow
buttons at the same time.
The display shows two arrows pointed
towards each other in the top area,
if the laser beam is aligned with the
middle.
The laser beam of the TUBUS 2 can be aligned horizontally with the unit‘s
longitudinal axis within a range of +/- 10°.
7.3 Measuring and accepting the tilt
NOTE
The display on the remote control is laterally reversed! A setting via the remote control
is usually made on the opposite side of the laser, with the view of the target plate and
the outlet of the laser beam.
7.4 Adjusting the laser direction
Button
Description
To change the tilt manually, press the MANUAL but-
ton. A hand symbol appears in the display and the tilt
value flashes.
The UP/DOWN arrow buttons can now be used to
set or adjust the tilt value. To do this, either press the
respective button briefly or keep it pressed.
To save the set value, press the TILT/OK button and
keep it pressed for approx. 3 sec. The value is saved,
if the tilt value in the display no longer flashes or an
acoustic signal sounds in IR mode and the laser beam
stops flashing. Manual mode is ended.
The TUBUS 2 remote control can be used to manually align the laser beam verti-
cally with the target plate and the tilt value can be accepted.
Summary of Contents for TUBUS 2
Page 1: ...EN Operating Instruction...
