NED
RMSL8K76CP/RMSL6K76CP/RMSL4K76CP UME-0094-02
25
3.4.2 How to supply from the CXP 1 connector (PoCXP)
Connect the power connector for PoCXP on the frame grabber board.
The type of power connector varies depending on the frame grabber manufacturer.
For details of connector type, supply voltage, etc., refer to the frame grabber board
instruction manual.
When the PC power supply is turned on, power is supplied via the CoaXPress cable.
Notes:
1)
Do not supply power (DC +12V to +15V) to the camera power connector.
3.5 LED Indicator Status
The status of the indicator varies depending on CoaXPress's Ver. This camera is
CoaXPress Ver1.1.1.
Table
3-5-1 Indicator status
LED Indicator Status
CoaXPress Ver.
1.1.1 (New)
1.0 (Old)
Camera Power Supply is off
LED off
Camera Booting Up (Power On)
Lights orange
Device Discovery
Lights orange for 0.5s
Line rate > ~1.6s *
1
Blinks orange
Low Speed Link disconnected (Cable disconnected)
Blinks red
Lights red
Unable to process commands (System crash) *
2
Lights red
Blinks red
Transmitting image packets (Acquisition Start =1)
Blinks green
Lights green
Not transmitting image packets (Acquisition Stop =1)
Lights green
Blinks green
*
1
When the line rate is close to 1.6s, the LED may flash orange and green alternately.
*
2
Turn on the camera power supply again.
