NED
RMSL8K76CP/RMSL6K76CP/RMSL4K76CP UME-0094-02
24
3.4 Power Supply
This camera can supply two kinds of power from the power connector and from the
CXP 1 connector (PoCXP).
For safety, please remove the power connector for PoCXP of the frame grabber
board when using the power connector.
3.4.1 How to supply from power connector
A single DC voltage (DC +12V to +15V) must be supplied to the power connector.
DC + 12 to + 15 V When the power is supplied, the indicator (orange LED) lights up,
after a few seconds it turns steady green and the camera enters the operating state.
Notes:
1) When selecting a power source, choose one with the capacity to allow for inrush
current.
(RMSL8K76CP is 15W, RMSL6K76CP is 12W and RMSL4K76CP is 10W or more is recommended)
2) Insert the cable plug securely until it locks into position. This is to prevent the
connector from coming loose during power transmission.
3) Take the necessary countermeasures in the electric supply line for lightning surge
protection, if the camera is used in the area where lightning strikes often occur.
4) Do not share the power supply and ground connection with the apparatus such as
the inverter controlled motor units or other devices that generate noise interference
to avoid the failure and malfunction of the camera. Place the camera far away from
the apparatus generating noise. Do not arrange the signal cables and the power
supply cable for camera adjacently.
5) If the lamp fails to illuminate even after power is switched on, turn off power
immediately. Inspect wiring. Check the voltage and capacity of the supplied power
source.
6) It is recommended that the shield processing of the power cable to be connected
with GND on the power supply side.
