7
© by NECTA VENDING SOLUTIONS SpA
0404 211-02
The spirals can be positioned with 22,5 degree steps by
pulling them towards the front and rotating them in the
direction of ejection.
Normally, the products can be dispensed without any
problems when the spiral end is in the lower centre posi-
tion.
The maximum size (see Fig. 5) and the number of prod-
ucts, the pitch and the direction of rotation of the spirals are
shown in the following table.
HYGIENE AND CLEANING
According to current health and safety regulations, the
operator of vending machines is responsible for their
hygiene and cleaning.
It is advisable to use sanitising products (chlorine based
detergent or similar) to clean all surfaces even if not in
direct contact with food.
Some parts of the machine can be damaged by strong
detergents; especially the clear polycarbonate panel for
which special care must be taken not to use tools that may
scratch it.
The manufacturer declines all responsibility for dam-
age caused by non-compliance with the above men-
tioned precautions and with current regulations.
At least every six months it is necessary to clean the
ventilation grilles of the cooling system using a vacuum
cleaner or compressed air, doing as follows:
- with the vending machine disconnected from the
power supply, remove the front grille, completely
undoing the two screws;
- remove the air intake grille.
- after cleaning the grilles, reassemble everything in the
reverse order
Fig. 7
1 - Tray groove
2 - Product support
Fig. 8
1 - Dispensing compartment
2 - Air-intake grille
3 - Front grille
A
.
m
m
B
.
m
m
°
N
0
8
6
7
6
4
6
0
6
7
4
5
0
5
8
6
4
2
4
0
1
0
4
6
3
1
1
4
3
0
3
3
1
0
3
6
2
5
1
4
2
0
2
9
1
)
°
0
8
1
(
4
2
0
2
9
1
+
9
1
The machine is supplied with a table indicating the opti-
mum setting for the different product types.
The configuration can be changed following the indications
of the relevant chapter.
Under no circumstances should sprayed water be
used.
Before any maintenance operation always switch the
machine off.
The integrity of the machine and compliance with the
standards of the relevant systems must be checked at
least once a year by qualified personnel.
Summary of Contents for Sfera
