NEC WL1700-MS, Installation Manual

Page: 130 / 226

Data Assignment
Chapter 4
INITIAL SETUP
96
24
Specify Transmitted Speed in Access Point.
Type set service-profile {Service Profile Name} transmit-rate {11a (802.11a)
| 11b (802.11b) | 11g (802.11g)} mandatory {data transmission rate to be
used <Mbps>} disabled {disabled data transmission rate <Mbps>}
beacon-rate {beacon rate:1.0 | 2.0 <Mbps>) | Auto} multicast-rate {multicast
rate<Mbps>} .
Selectable rate when 802.11a standard is used
: 6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
Selectable rate when 802.11b standard is used
: 1.0, 2.0, 5.5, 11.0
Selectable rate when 802.11g standard is used
: 1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
The following is an example when mandatory data transmission rate ( 1.0
Mbps and 2.0 Mbps), disabled data transmission rate ( 11.0 Mbps), beacon rate
( 2.0 Mbps), and multicast rate ( auto ) are assigned to Service Profile
( Dot1x-B ) in the command.
25
Specify a User Idle Timeout value.
If a terminal does not respond within a certain period of time (User Idle
Timeout), the Controller disassociates the terminal.
Type set service-profile {Service Profile Name} user-idle-timeout {second} .
The following is an example when User Idle Timeout ( 300 seconds) is
assigned to Service Profile ( Dot1x-B ) in the command.
WL111111# set service-profile Dot1x-B transmit-rate 11b mandatory
1.0,2.0 disabled 11.0 beacon-rate 2.0 multicast-rate auto
WL111111#
set service-profile
Dot1x-B
user-idle-timeout
300