NEC Versa LXi Series, Service And Reference Manual

Page: 42 / 95

2-22 System Configuration and Setup
Follow these steps to enable the BIOS flash switch.
1. Make sure the system is powered off and that no peripheral devices are attached.
2.
Open the LCD panel.
3.
Locate the two keyboard retainers, press on and slide each one towards the outside edge of
the system, and remove them.
Removing the keyboard retainers
4. Gently lift up the edge of the keyboard nearest the LCD and slide the keyboard toward the
LCD screen to release the tabs that secure it.
Lifting the keyboard
Be careful not to disconnect the keyboard or keyboard cable entirely
from the system.
5.
Gently rest the keyboard on top of the base unit to view and access the dip switch block. Be
careful not to twist or disconnect the keyboard cable.
6.
Locate the dip switch block. Using a fine-tipped object, change switch 5 to “ON” to enable
the BIOS flash.