TERMINAL SETUP
30
TO SET SCREEN SAVER
The procedure below shows how to set the Screen Saver. Screen
Saver works after the telephone in an idle state for a certain period
of time.
1.
Press Menu key while terminal is in an idle state..
2.
Select
□
1 User Settings.
3.
Select
□
3 Display.
4.
Select
□
3 Screen Saver.
5.
Select
□
1 Screen Saver Mode.
6.
Select
either
□
1 Disable or
□
2 Enable.
■Default setting is
□
1 Disable.
■The enabled item is highlighted.
7.
The display goes back to the Screen Saver screen.
When
□
2 Enable is selected on
6
, Select
□
2
Wait Time.
Input
Wait Time
to launch the screen saver (1-999min)
and then press
Enter
key or the
OK
soft key.
Default value is 120 min.
If the same screen is displayed for a long time, There are
cases where LCD burning occur.
To prevent it, recommend you to enable screen saver.
TO ENABLE/DISABLE BACKLIGHT
The procedure below shows how to enable/disable the backlight
of LCD.
The backlight illuminates (for approximately 10 seconds) when
you press any key or lifts the handset.
1.
Press Menu key while terminal is in an idle state..
2.
Select
□
1 User Settings.
3.
Select
□
3 Display.
4.
Select
□
4 Back Light.
5.
Select desired setting from the following list.
No.
Menu Item
Meaning
1
Disable
Backlights of LCD are disabled.
2
Enable
Lito enterBacklights ).
The enabled item is highlighted.
