Setting System Board Jumpers 5-5
Password clear jumper
5.
Reinstall any removed expansion boards (see “Installing
an Expansion Board” in this guide).
6.
Replace the system unit cover (see “Replacing the
System Unit Cover” in this guide). Reconnect the power
cables and peripheral devices.
7.
Power on the system.
SETTING THE CACHE JUMPER
If you install an optional cache module, you are required to
set the cache jumper. Use the following procedure to set the
cache jumper.
!
CAUTION
Only change (or check) the cache jumper setting if
you are installing optional cache. Otherwise, keep
the jumper at its factory setting.
1.
Power off and unplug the system and any peripherals.
2.
Remove the system unit cover (see “Removing the
System Unit Cover” in this guide).
3.
Locate the L2 SRAM Cache jumper on the system board
(see the figure “SRAM cache jumper” earlier in the
chapter).
Password Clear
Normal (default)
Password Clear
Summary of Contents for POWERMATE VE - 03-1996
Page 61: ...3 28 Installing Options ...
