Installing System Upgrades 4-25
Installing the 3 1/2-Inch Diskette Drive
Attach the diskette drive to the bracket and install the bracket in the
chassis as follows.
1.
Attach the diskette drive to the bracket with the two previously
removed screws.
2.
Tilt the bracket and slide into the back of the front panel until it stops.
Installing the 3 1/2-inch diskette drive
A – Bracket Screw Hole
C – Drive Fastening Screws (2)
B – Bracket
D – Front Panel
3.
Lift the back of the drive slightly and slide it forward to engage the
two tabs on the bracket with their slots in the front panel.
4.
Align the screw hole at the end of the bracket with its corresponding
hole in the chassis.
5.
Install the previously removed screw through the bracket and into the
chassis to fasten the bracket in place.
6.
Lift up the cable retainer on the drive connector and insert the drive
cable into the connector. Push down on the retainer to lock the cable
in place. Check that the cable is secured.
7.
Replace the system unit cover (see “Replacing the Cover”).