NEC PD750004, User Manual, Page: 166 / 342

146
µPD750008 USER'S MANUAL
Serial interface operation mode selection bit (W)
CSIM4 CSIM3 CSIM2 Shift register sequence SO pin function SI pin function
0 1 1 SIO
7-0
<—> XA SB0/P02 (N-ch P03 input
(Transfer starting with MSB) open-drain I/O)
1 P02 input SB1/P03 (N-ch
open-drain I/O)
Serial clock selection bit (W)
CSIM1 CSIM0 Serial clock SCK pin mode
0 0 External clock applied to SCK pin Input
0 1 Timer/event counter output (TOUT0) Output
1 0 f
X
/2 6 (65.5 kHz)
1 1
Remark The value at 4.19 MHz is indicated in parentheses.
(b) Serial bus interface control register (SBIC)
To use the two-wire serial I/O mode, set SBIC as shown below. (For details on SBIC format, see (2)
in Section 5.6.3.)
SBIC is manipulated using a bit manipulation instruction.
When the RESET signal is input, SBIC is set to 00H.
In the figure below, the hatched portions indicate the bits used in the two-wire serial I/O mode.
Remark (W): Write only
Command trigger bit (W)
CMDT Control bit for command signal (CMD) trigger output. By setting CMDT = 1, the SO latch is
cleared. Then the CMDT bit is automatically cleared.
BSYE ACKD ACKE ACKT CMDD RELD CMDT RELT
FE2H
SBIC
7 6 5 4 3 2 1 0
Address
Bus release trigger bit (W)
Command trigger bit (W)
Do not use these bits in the
two-wire serial I/O mode.