31
2. Projecting an Image (Basic Operation)
❽
Turning off the Projector
To turn off the projector:
1. First, press the
(POWER) button on the projector
cabinet or the STANDBY button on the remote control.
The [POWER OFF / ARE YOU SURE ? / CARBON SAV-
INGS- SESSION 0.000[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the
(POWER) or the STANDBY button again.
The lamp will go off and the power supply will be cut. If
no operation is performed on the projector and no signal
is input to the projector, the projector will be in standby
state. The POWER indicator will light in orange (In the state,
the standby mode is NORMAL and the PROFILE for the
WIRED LAN is available.).
Power On
Steadily lights in
blue
Sleep
Blinks in orange
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the
AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off.
• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.
• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so could
deteriorate the projector’s AC IN terminal or the power plug’s contact. To turn off the AC power while an image is being projected,
use the power strip’s switch, the breaker, etc.
• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closing
the menu. Doing so can cause loss of adjustments and settings.
