Important Information
–
xv
–
Do not install in places subject to vibrations or shocks.
If installed in places where the vibrations from power sources and the like are conveyed, or in vehicles or on vessels,
etc. the projector could be affected by vibrations or shocks that may dam- age internal parts and lead to malfunction.
Install in a place not subject to vibrations or shocks.
Do not install near high voltage power lines or power sources.
The projector may be affected by interference if it is installed near a high voltage power line or a power source.
Do not install or store in such places as those described below. Doing so could lead to malfunction.
-
Places where strong magnetic fields are generated
-
Places where corrosive gases are generated
If intense light like laser beams enters from the lens, it could lead to malfunction.
Consult your dealer before using in places where much cigarette smoke or dust is present.
When using the projector at altitudes of about 1,600 m/5,500 feet or higher, be sure to set the [FAN MODE] to [HIGH
ALTITUDE]. If not, the inside of the projector may get hot, leading to malfunction.
When the projector is used at high altitudes (places where the atmospheric pressure is low), it may be necessary to
replace the optical parts (light source, etc.) sooner than usual.
About moving the projector
-
Be sure to mount the included lens cap to protect the lens from scratches.
-
Do not subject the projector to vibrations or strong shocks. The projector could be damaged otherwise.
Improper handling, such as carrying the projector by the tilt feet or using it leaned against a wall, could lead to mal-
function.
Do not touch the surface of the projection lens with bare hands.
Fingerprints or dirt on the surface of the projection lens will be enlarged and projected on the screen. Do not touch
the surface of the projection lens.
Do not unplug the power cord from the projector or the power outlet while projecting. Doing so could cause dete-
being projected, use a power strip switch, a breaker, etc.
About handling of the remote control
-
is exposed to strong light or if there are obstacles between them that obstruct the signals.
-
Op
sensor.
-
Do not drop the remote control or handle it improperly.
-
Do not let water or other liquids get on the remote control. Should the remote control get wet, wipe it off imme-
diately.
-
Avoid using in hot and humid places as far as possible.
-
When planning not to use the remote control for long periods of time, remove both batteries.
Take measures to prevent external light from shining on the screen.
Make sure only the light from the projector shines on the screen. The less external light on the screen, the higher the
contrast and the more beautiful the images.
About screens
Images will not be clear if there is dirt, scratches, discoloration, etc. on your screen. Handle the screen with care,
protecting it from volatile substances, scratches and dirt.
