29
2. Projecting an Image (Basic Operation)
TIP:
• To obtain the best focus, perform the following (for permanent installation)
Preparation: Warm up the projector for one hour.
1. Press the FOCUS button and the
◀▶
buttons to check the adjustable focus range. For checking it by the remote control, press
and hold the CTL button and press VOL./FOCUS +/− button. If the projector in use is not within the adjustable focus range,
move the projector back and forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (
→
• For displaying the test pattern by the remote control, press TEST button.
3. Press the FOCUS button to display the Focus Adjustment Bar, then press the < button until the pixel lattice of the test pattern
cannot be seen any more.
• The FOCUS adjustment bar displaying position can be shifted or be turned off temporarily. (
→
page
)
4. Keep pressing the
▶
button until you obtain the best focus.
For obtaining the best focus by the remote control, press the VOL./FOCUS + button while holding to press the CTL button.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
5. Turn the edge focus ring clockwise or counterclockwise to adjust the focus at the edges of the projected image.
Applicable lens unit: NP39ML-4K
1. Focus on the projected image around the optical axis. (Powered focus)
Press the FOCUS button to display the focus adjustment bar. Press the
◀▶
button to adjust the focus near the
optical axis.
• On the remote control, while pressing on the CTL button, press on VOL/FOCUS (+) or (−) button.
•
◀
or
▶
buttons on the remote control are also available to adjust FOCUS while the FOCUS adjustment bar is
displayed on.
Optical axis