7
1. Introduction
Rear
AC IN terminal
Connect the supplied
power cord’s three-pin
plug here, and plug the
other end into an active
wall outlet. (
→
page
Theft prevention screw
hole for the lens unit
Main power switch
While AC power is being supplied, set the
main power switch to ON position (|), then
your projector will enter a standby state.
Power Cord Stopper
(
→
page
* Security and theft protection lock compatible with Kensington security cables/equipment.
For products, visit Kensington’s website.
Security Bar
Fixing a theft prevention
device.
The security bar accepts
security wires or chains
up to 0.18 inch/4.6 mm in
diameter.
Handle (located on 4 posi-
tions)
For transportation
NOTE:
• For moving the projector,
make sure you have at least
two people. At the same
time, do not grip and hold
the projector other than by
these handles. Attempting
to move the projector alone
could result in back pain or
other injuries.
Intake vent
Takes in air to cool the unit.
(
→
page
Terminals
(
→
page
Exhaust vent
Heated aiir is exhausted
from here.
(
→
page
Controls
(
→
page
)
Security Slot ( )*