Page 13
Important Information
Projectors are not designed to be stacked on top of each other unless a rigging frame is used.
When stacking projectors, the stack MUST be vertical, to ensure that the stresses are distributed to
all four chassis corners.
Power supply
The projector is so designed that it operates with the power supply voltage described below.
•
AC200–240V 8.2 A 50/60Hz Single-phase
Ensure that your power supply fits this requirement before attempting to use your projector.
Use only the power cable provided.
Use a power cable that meets the standards and power supply voltage of the country where you are
using the projector. Refer to user’s manual for details on connecting the power cable.
Ensure that the power outlet includes a Ground connection, as this equipment MUST be earthed.
Handle the power cable carefully. A damaged or frayed power cable can cause electric shock or fire.
•
Do not bend or tug the power cable excessively.
•
Do not place the power cable under the projector, or any heavy object.
•
Do not cover the power cable with other soft materi- als such as rugs.
•
Do not heat the power cable.
Placing the power cable and the signal cable closely to each other can cause beat noise. If this
happens, keep the two separated so that beat noise is not generated. Beat noise is corruption of the
picture often seen as a rolling band moving through the image.
Do not touch the projector or the power plug during a thunder storm. Doing so can cause electrical
shock or fire.
When installed on the ceiling, install the breaker in a location that is easy to reach by hand.
Do not unplug the power cable from the wall outlet or projector when the projector is powered on.
Doing so can damage the projector. Do not unplug in the following circumstances:
•
While projecting images
•
While cooling after the projector has been turned off. (The POWER button LED blinks in
green, the SYSTEM status indicator blinks in amber and the LCD screen shows the following
message: “Now processing, please wait...”)
Do not turn of the AC power for 90 seconds after the laser is turned on and while the POWER
indicator is blinking green.
Doing so could cause premature laser failure.
Use of a wall outlet with a 20 A or more circuit breaker is recommended.
