NDA-24299
CHAPTER 5
Page 95
Revision 1.0
DATA PROGRAMMING
Assignment of FCH Related Data
STEP 1:
ANPDN/ANPDL
Assign the first digit of the LCR/LCRS access code. When the access code is common to all nodes,
use the ANPDN command. When the access code is assigned for each node, use the ANPDL
command.
TN=1
1st DC=8
CI=N (Normal)NND=1
TN=1
1st DC=8
CI=H (Hooking)NND=1
STEP 2:
ASPAN/ASPAL
Assign the LCR/LCRS access code for a dummy route number. When the access code is common to
all nodes, use the ASPAN command. When the access code is assigned for each node, use the ASPAL
command.
ACC=8
CI=N (Normal)
SRV=LCR/LCRSLGRT=Dummy route number
ACC=8
CI=H (Hooking) SRV=LCR/LCRSLGRT=Dummy route number
STEP 3:
AMND
Using AMND, assign the Maximum Necessary Digits to be received by Register (ORT) circuit.
DC=8110
MND=8
STEP 4:
ARNPL
Using ARNPL, assign the access code for each external trunk route but not for a dummy route.
RT=10
ACC=8
RT=200
ACC=9
Note:
When entering the data in STEP 1, 2, 6, 7, and 8, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
•
When writing the data on the LDM:
ANPDL
→
ASPAL
→
AFRSL
→
AOPRL
→
AADCL
(STEP 1)(STEP 2)
(STEP 6)
(STEP 7)(STEP8)
•
When writing the data on the NDM:
ANPDN
→
ASPAN
→
AFRSN
→
AOPRN
→
AADCN
(STEP 1)(STEP 2)
(STEP 6)
(STEP 7)(STEP8)