CHAPTER 3
ND-70373 (E)
Page 22
Revision 1.0
SYSTEM STARTUP
1.4 Standard Service Software Installation
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
<7-Segment LED Indication on the EMA card>
<Install End>
END
START
Set the SENS switch
corresponding to the
Insert the FD “Standard
Service Software”
Make sure the write-protect
tab is set to “write enable
(permit)” position on the
“Standard Service
system to have DATA
installed (CPU0, CPU1)
to “3” on the EMA card.
Slide the write-protect tab
to “write inhibit (protect)”
position on the “Standard
Service Software” FD. Note
Software” FD. Note
into the FDD.
Removal or Make Busy of the HFD
card is not allowed while the Floppy
Disk or Hard Disk is being accessed.
WARNING
Flip the MBR key on the CPR
[DOWN
→
UP
→
DOWN].
Note:
Skip this step in the U.S.A, Canada and Australia.
