NEC N8804-005, User Manual

Page: 32 / 40

- 32 -
4.Setup procedure
This product is set up according to the following procedure.
Installation of this product →Page 32
This product is installed in the main body device.
Network cable connection →Page 33
The network cable is connected with this product.
Driver installation → Refer to "User's Guide" of the
computer.
The driver for the operating system used is installed.
4-1.Installation of this product
This product is installed. Refer to the “User's Guide” of the computer
.
Do not pull the cable when disconnecting it.
When disconnecting the cable from the device, hold the cable connector/cable tag
and pull it straight out. Pulling the cable out by the cable portion or giving
mechanical stress to the connector could damage the cables and connectors to
result in an electrical shock hazard or a fire.
High temperature
Immediately after powering off the system, system components such as hard
disk may be very hot. Wait for the server to cool down completely before
adding/removing components.
Make sure to complete installation.
Firmly install all power cords, interface cables and/or boards. An incompletely
installed component may cause a contact failure, resulting in fire and/or smoke.
Important
„ If the power to the computer is on (power lamp on), shut down the
operating system and then turn off the computer.
CAUTION
CAUTION