*856-128776-004-00X*
6
An error message appears while booting the server:
Refer to the manual provided with the CPU blade.
If the slot containing the card is assumed to be the error cause, check the
following:
An error occurred in the slot to which the card is installed.
Connect the card once again.
NOTE:
If the same error message still appears, remove the card,
and install it into another mezzanine slot. Restart the server
and check the POST screen. If POST completes normally,
the server may be faulty. Contact your service
representative.
The card does not work normally:
If the OS or the application program does not work normally after installed the
card, check the following points. See also the manual that comes with the CPU
blade.
Has the LAN driver been installed in the relevant CPU blade? Or, is the
CPU Blade setup correctly?
Refer to the manual provided with the CPU blade.
Are the card and cables connected firmly?
Firmly connect them once again.
Are the mezzanine slot to which the card is installed, location of the
slot to which the CPU blade is installed, and the installation location of
switch module corresponding to the card such as 10Gb Pass-Through
Card is installed appropriate?
Refer to the manuals of the CPU Blade, Blade Enclosure, installed switch
module.
NOTE:
If the same error persists, remove the card, restart the CPU
blade, and check the POST screen. If POST completes
normally, the card may be faulty. Contact your service
representative.
Bus type
Standard
PCI-EXPRESS 2.1 compliant
Rate
5GT/s
Lane
X8
LAN
Ports
2
Speed
10G/1Gbps
Controller
Broadcom BCM57810S
Dimensions
Width
Length
115mm
100mm
(card w/o/ Connector and Heat Sink)
Weight
93g
Supply Voltage
12V / 3.3Vaux
Power Consumption
(Maximum)
9W
Environment
Operating
Temp. : 0 - 40C
Humid. : 20 - 80%
Storage
Temp. : -10 - 55C
Humid. : 20 - 80%
RH (non-condensing)
N8403-065F
N8403-067F
Dual Port 10GBASE Adapter
User’s Guide
1st. Edition
July 2012
NEC Corporation
7-1 Shiba 5-Chome, Minato-Ku, Tokyo 108-8001, Japan
Troubleshooting
Specification
