NEC N8190-159, User Manual

Page: 82 / 86

6> Execute “hbacmd SetPersistentBinding” for this product and set a persistent binding between the
WWPN address of tape storage/ disk array and the SCSI Bus target. If binding target device is
more than one, repeat executing “hbacmd SetPersistentBinding” for the same product.
Use a value
͆ P ͇ for the parameter of both <Scope> and <BindType>. Use the same value for
<SCSI Bus>, <SCSI Target> and <ID(Port WWN)> checked in item5>.
„ Refer to next item “Hbacmd command” for more information of
"hbacmd SetPersistentBinding"
㻌
&?3URJUDP)LOHV?(PXOH[?8WLO?2&0DQDJHU!KEDFPGVHWSHUVLVWHQWELQGLQJI
D33
6HW3HUVLVWHQW%LQGLQJIRUID33
%LQGLQJFRQILJXUHGEXWQRWDFWLYH5HERRWUHTXLUHG
7> Execute “hbacmd persistentbinding” with parameter <Source> =“C” for this product that is set
persistent binding and confirm the binding configurations (SCSI Bus Number, SCSI Target num and
Port WWN) are correct.
㻌
&?3URJUDP)LOHV?(PXOH[?8WLO?2&0DQDJHU!KEDFPGSHUVLVWHQWELQGLQJID
F
3HUVLVWHQW%LQGLQJIRUID
%LQG7\SH::31
)&3,'
6&6,%XV1XPEHU
6&6,7DUJHW1XP
1RGH::1
3RUW::1
26'HYLFH1DPH
„ If there are any wrong configurations, remove that configurations by
executing "hbacmd RemovePersistentBinding" and set persistent bindings
again.
„ If you want to remove all configuration of the one product, you can remove
all configuration for this product by executing
"hbacmd RemoveAllPersistentBinding".
„ Refer to next item “Hbacmd command” for more information of
“RemovePersistentBinding” and “RemovePersistentBinding”
8> Repeat the same step for the remaining this product, to set persistent bindings.
9> Reboot the system and log in it using the Administrator.
䣖䣫䣲䣵
䣖䣫䣲䣵
Port WWN of 5.
SCSI Bus/Target of 5 㻚