(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.
This product’s PCI Express connector type is x8.
(2) Bracket
Bracket to fix this product to the extended slot of Computer.
When fixing this product to a PCI slot optimized for the low profile type, replace the
bracket with the attached low profile one.
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.
Don’t insert the SFP+ module of this product to the other N8190-157 or the other
Fibre Channel device.
(4) LED
Two LED give a visual indication of the operating state.
㻌
The slow blink rate is 1 Hz. the flashing state is an irregular on/off appearance reflecting program
activity.
Green LED
Yellow LED
State
Off
Off
Boot Failure (Dead Board)
Off
On
POST Failure (Dead Board)
Off
Slow Blink
Boot Failure after POST
Off
Flashing
POST Processing in Progress
On
Off
Failure While Functioning
On
On
Failure While Functioning
On
Blink(3 beat)
8Gbps Link Rate – Normal, link up
On
Blink(4 beat)
16Gbps Link Rate – Normal, link up
Slow Blink
Off
Normal – Link Down
If the product fails at POST, please check the following items.
- Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
(5) Fibre Channel Connector
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(6) WWPN Address
WWPN (Worldwide Port name) Address is displayed by this label.
The WWPN address may be required to use an additional function of Fibre
Channel device.
(7)IEEE Address
IEEE Address is displayed by this label.
The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN)
address.
䣖䣫䣲䣵
䣖䣫䣲䣵
䣖䣫䣲䣵
䣖䣫䣲䣵
䣐䣱䣶䣫䣥䣧
䣐䣱䣶䣫䣥䣧
