4
Attention to Power or Power Cord
Do not hold the DC cable with a wet hand.
Do not disconnect/connect the cable while your hands are wet. Failure to follow this
warning may cause an electric shock.
Do not install the device while the power is turned on.
Unplug the AC power cord from the main power source when installing/uninstalling
the device to/from server or connect it with the enclosure. Failure to follow this
warning may cause an electric shock.
Insert the DC cable into the outlet as far as it goes.
Heat generation resulting from a halfway inserted DC cable (imperfect contact) may
cause a fire. Heat will also be generated if condensation is formed on dusty blades
of the halfway inserted cable, increasing the possibility of a fire.
Do not connect the Built-in LTO by unspecified cabling.
Connecting or cabling with DC cable should be done in accordance with the
procedure specified in the User's Guide.
Unspecified connecting or cabling may cause an electric shock or a fire.
Do not use any damaged power cord.
If the power cord is damaged, immediately replace it with a new part of same type.
Do not repair the damaged section for reuse. Otherwise, the section repaired with
vinyl tape or the like will be overheated to cause an electric shock or a fire.
Use the authorized cable only.
Use only the specified cable when connecting the Built-in LTO with a server. Use of
an unspecified cable or connection by unspecified cabling may cause a fire.
