![background image](http://html.mh-extra.com/html/nec/n8118-01/n8118-01_user-manual_247553010.webp)
- 8 -
Do not hold the cable harness when disconnecting it.
When disconnecting a power cable from the server, hold the cable connector and tab,
pull it straight out. Pulling the cable out by the cable portion or giving mechanical
stress to the connector could damage the cable and connector to result in an electric
shock hazard or a fire.
Pay attention to hot surface.
Immediately after the server is powered off, its internal components such as hard disk
drives are very hot. Leave the server until its internal components fully cool down
before installing/removing any component.
Insert the board firmly.
Connect the board into PCI slot securely. Loose connection may cause fumes or fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug (imperfect contact) may
cause a fire. Heat will also be generated if condensation is formed on dusty blades of
the halfway inserted plug, increasing the possibility of fire.
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this
warning may cause an electric shock.
Do not use the product in an environment where corrosive gas is present.
Do not install the product in a place subject to corrosive gases including sodium
chloride, sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, or
ozone. Do not install the product in an environment that contains dust, chemicals that
accelerate corrosion such as NaCl or sulfur, or conductive materials. Failure to follow
this warning may cause the wiring on the printed circuit board to short-circuit, leading
to fire. If you have any questions, contact your maintenance service company.
CAUTION