NEC N8103-197, User Manual

Page: 28 / 32

- 26 -
2-1.Installation of a Bracket
A full height PCI bracket is attached to this product at factory shipment. If you insert this product in a
low profile PCI slot, you have to replace the bracket with a low profile one that comes with this
product.

Exchange of a bracket uses the screwdriver suitable for the size of a screw.
1. Remove the two screws.
2. Remove the bracket from this product.
3. Install the low profile bracket to this product.
4. Tighten the two screws.

Follow the same procedure when the low profile bracket is replaced with the
standard bracket.

Make sure to keep the removed bracket carefully.
2-2.Installation to the server
1. Confirm the power to the server is off, then unplug the power cord from the electrical outlet.

If the power to the server is on (power lamp on), shut down the operating system
and then turn off the server.
2. Remove the cover and other components of the server if necessary following the instructions in
the user's guide of the server.
3. Install this product in the PCI slot as following the instructions described in the user's guide of
the server.

The method of installing and removing the PCI card and the location of the PCI
slot differ in different servers. Read the user's guide of the server for confirmation.

If this product is not correctly connected to the PCI slot of the server, remove the
product and connect it again. Using excessive force can lead to damage.
4. Replace the cover and components removed in item 2.
5. Plug the power cord of the server into the electrical outlet.
Tips
Tips
Check
Notice
Notice