NEC N8100-958F, User Manual

Page: 259 / 346

Upgrading Your Server 9-5
DEVICE INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
Hard Disk Drive
The server has three device bay slots to install hard disks with the SCA2 interface (Ultra 160 SCSI)
in the disk bay of the front of the server.
IMPORTANT:
„
Do not use any hard disks that are not authorized by NEC. Installing
a third-party hard disk may cause a failure of the server as well as
the hard disk. Purchase hard disks of the following models:
<SCSI hard disk drive>
– N8150-161F (18.1 GB, 10,000 rpm, Ultra 320)
– N8150-162F (36.3 GB, 10,000 rpm, Ultra 320)
– N8150-163F (73.2 GB, 10,000 rpm, Ultra 320)
– N8150-171F (146 GB, 10,000 rpm, Ultra 320)
– N8150-164F (18.1 GB, 15,000 rpm, Ultra 320)
– N8150-165F (36.3 GB, 15,000 rpm, Ultra 320)
– N8150-172F (73.2 GB, 15,000 rpm, Ultra 320)
<SATA hard disk drive>
– N8150-184 (80 GB, 7,200 rpm, serial ATA)
– N8150-185 (120 GB, 7,200 rpm, serial ATA)
– N8150-184 (250 GB, 7,200 rpm, serial ATA)
„
To make array configuration, specify RAID0, RAID1 or RAID5 as
the RAID level.
All drive slots may contain a hard disk approximately 25.4 mm (1 inch) high. The drive IDs are
always assigned to hard disks as shown below.
SCSI ID0 SCSI ID1 SCSI ID2
Channel 1 Channel 2 Not used.