Quick Start
To attach the MultiSync
®
LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable
to the connector of the display card in your system
(Figure A.1)
. Tighten all screws.
For the Mac: Connect the MultiSync LCD
400V
™
Macintosh cable adapter to the computer
(Figure B.1)
. Attach the 15-pin mini D-SUB end of the appropriate signal cable to the
MultiSync LCD
400V
Macintosh cable adapter
(Figure B.1)
. Tighten all screws.
NOTE: To obtain the MultiSync LCD
400V
Macintosh cable adapter,
call NEC Technologies at (800) 820-1230.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on
the back of the monitor
(Figure C1)
.
NOTE: Incorrect cable connections may result in irregular operation, damage
display quality/components of LCD module and/or shorten the module’s life.
4. Connect one end of the power cord to the MultiSync LCD Series monitor and the other
end to the power outlet
(Figure D.1)
.
5. Turn on the monitor
(Figure E.1)
and the computer.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM
™
controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the
Controls
section of this User’s Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
2
Figure A.1
Figure B.1
15-pin
mini D-SUB
Mac Adapter
(not included)
15-pin
mini
D-SUB
78133331
9/25/98, 12:46 PM
4