NEC MultiSync 20WGX2 Series, User Manual

Page: 11 / 132

English
English-3
Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your
system ( Figure A.1 ). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system ( Figure A.2 ). Tighten all screws.
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to
the Macintosh cable adapter ( Figure B.1 ). Tighten all screws.
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. Remove the connector cover ( Figure C.1 ).
4. Place hands on each side of the monitor to tilt the LCD panel 30 degrees angles ( Figure C.2 ).
5. Connect all cables to the appropriate connectors through the square hole in the stand ( Figure C.3 ).
Figure A.1 Figure B.1
Macintosh
Cable Adapter
(not included)
Figure A.2
DVI signal cable
Figure C.1 Figure C.2
Figure C.3
01_English 1/12/05, 12:49 3