English-11
English
Figure F.1
100 mm
100 mm
Weight of LCD assembly: 7.5 kg
Flexible Arm Installation
This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
•
Follow the instructions provided by the manufacturer of the monitor mount.
•
To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See page 21 for details. Remove the monitor stand before mounting.
* Contact your dealer for more information.
Remove the Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Make sure to rotate the screen 90° counter clockwise to the landscape position (
Figure S.1
).
4. Place the monitor face down on a non-abrasive surface. Be sure to not apply any stress or pressure to the front sensor.
To avoid this, lay the monitor face down on a desk or table with the front sensor situated off the edge (
Figure S.2
).
5. Slide the cable cover up.
NOTE:
The cable cover is not removable.
6. Place hand on the back side of the monitor and lift up the stand.
7. Remove the 4 screws connecting the monitor to the stand. Remove 2 bottom screws fi rst (
Figure S.2
).
8. Lower the stand and slide the cable cover down.
9. Remove 2 top screws (
Figure S.3
).
Reverse process to re-attach the stand.
NOTE:
Handle with care when removing the monitor stand.
Figure S.3
Figure S.2
Front sensor
Figure S.1
Mount the Flexible arm
1. Use the 4 screws that were removed from the stand removal to attach the fl exible arm to the monitor
(
Figure F.1
).
Caution:
•
The monitor should only be used with an approved arm (e.g. TUEV GS mark).
•
When mounting, use the screws (4 pcs) that were removed from the stand.
Alternatively, use M4 size screws with a maximum length equal to thickness
of bracket and 10mm, to avoid damage to the monitor.
The recommended torque is 0.98 - 1.37N•m.
•
To avoid blocking the air circulation, keep adequate space above and
behind the monitor.
Mounting Bracket
Screw
Washer
Unit
10 mm
Thickness of bracket
and washer