English-11
English
100 mm
100 mm
Figure F.1
Weight of LCD assembly: 7.8 kg
Figure S.1
Flexible Arm Installation
This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
• Follow the instructions provided by the manufacturer of the monitor mount.
• To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See pages 23-26 for details. Remove the monitor stand before mounting.
Remove the Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest
position.
3. Place the monitor face down on a non-abrasive surface.
Be sure to not apply any stress or pressure to the integrated front sensor.
To avoid this, lay the monitor face down on a desk or table with the
integrated front sensor, situated off the edge (
Figure S.1
).
4. Place one hand around the base and one hand on the
Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the
arrows (
Figure S.1
).
5. Lift up the stand to unhook it from the monitor (
Figure S.1
).
The monitor can now be mounted using an alternate method.
Reverse the process to reattach stand.
NOTE:
Handle with care when removing the monitor stand.
Mount the Flexible arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how to Remove the Monitor Stand for Mounting to remove the
stand.
2. Use the 4 screws and attach the arm to the monitor (
Figure F.1
).
Caution:
Use ONLY the screws (4 pcs) that are included or the screws M4 size
(Length: thickness of bracket and 10-12 mm) when mounting to
avoid damage to the monitor and stand. To fulfi l the safety requirements the
monitor must be mounted to an arm which guaranties the necessary stability
under consideration of the weight of the monitor. The LCD monitor should only
be used with an approved arm (e.g. TUEV GS mark).
Mounting
Bracket
Screw
Washer
Unit
10-12 mm
Thickness
of bracket
and washer
NOTE:
Tighten all screws.
(The recommended torque is 0.98 - 1.37N•m)
