English-8
4. Connect all cables to the appropriate connectors (
Figure C.1
). When using the USB cable, connect the B type connector to
the USB upstream port on the right back side of the monitor and the A type connector to the USB 2.0 downstream port on
the computer (
Figure C.1a
). If using the cord from a USB device, plug into one of the downstream ports of the monitor.
NOTE:
1. Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module
and/or shorten the module’s life.
2. For re-calibration and display management, the USB cable shipped with the display must be connected with a
USB 2.0 port of the computer as well.
NOTE:
Up to 5 sub monitors may be daisy-chained through the USB hub.
Figure C.1
Highest
Stand
Position
Power cord
30° Tilt
Figure C.1a
A Type
B Type
A Type
B Type
Sensor Port*
1
DVI-D Cable
DisplayPort Cable
USB Upstream Port
USB Downstream Port
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (
Figure C.2
and
Figure C.3
).
6. Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.
Figure C.2
Figure C.3
USB Cable
Power Cord
DVI-D Cable
Power Cord
DVI-D Cable
USB Cable
DisplayPort
Cable
DisplayPort Cable
*
1
Connect the optional USB color sensor to this port for self calibration. (See page 30)
Please only use an USB color sensor according to our specifi cations.
