NEC MD205MG-1 - MultiSync - 20.1" LCD Monitor, Installation & Maintenance Manual

Page: 13 / 84

English.3
English
Display Card Installation
1. Following your PC manufacturer’s guidelines, open your computer to access the PCI, AGP or PCI E slot.
2. Place the display card into an available PCI, AGP or PCI E slot and secure all screws.
3. Replace the computer cover.
NOTE:
For information on installing drivers, display modes in multimonitor mode, setting the dip switches,
please refer to the display card manufacturer’s documentation.
Connecting the LCD to Your PC
Once the display card is successfully installed, follow these instructions to connect the display to your PC.
1. Shut down your computer and turn off the power.
2. Connect the DVI-D signal cable to the connector of the display card in your system (
Figure A.1 ).
Tighten all screws.
NOTE:
For dual displays, plug a DVI-D cables into Port 1 and Port 2 of the display card
(
Figure A.1).
For further information on display card installation, refer to the display card manual.
3. Rotate the screen to portrait mode. Refer to “Screen Rotation” section in this manual.
4. Remove the connector cover by pressing this mark (III) to unlock. Slide the cover to remove
(Figure B.1)
.
5. Connect the DVI-D signal cable to the connector on the back of the display (Figure C.1) .
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD
module, and/or shorten the module life.
6. Connect one end of the power cord to the AC inlet on the back of the display and the other end to the power outlet
(
Figure C.1
). Replace the connector cover.
NOTE:
Please refer to the “Power Cord Important Information” section of this manual for proper selection of AC
power cord.
7. Place the DVI cable and the power cable into the specific hooks as indicated ( Figure D.1 ).
NOTE: Make sure all cables are resting flat against the stand.
Please check Raise and Lower, Screen Rotation, and Tilt and Swivel functions (page 5) when you manage
cables.
Quick Start
Figure A.1
Port 2 for Dual
Display
Figure C.1 Figure D.1 Figure B.1
01_MD205MG-1_INSTALL_EN.P65 7/5/08, 10:09 AM 3