NEC LL009F, User Manual

Page: 61 / 123

- 61 -
5.2 Connection Settings
When using the Autoloader's Ethernet function, the following items must be set appropriately.
These items can be set and checked via the operation panel. For description of how to
change these settings, see “4.4.4(3) CONFIGURE NETWORK SETTINGS menu”.
Consult with a network manager concerning the settings for these items.
Item Default value Description of setting
IP ADDRESS 192.168.1.1 Autoloader device's IP address
When using an Ethernet function, the appropriate
IP address must be set. This can also be set
automatically by DHCP.
IP SUBNET
MASK 255.255.255.0 Network's subnet mask
When using an Ethernet function, the appropriate
subnet mask must be set. This can also be set
automatically by DHCP.
IP GATEWAY 0.0.0.0 The gateway is specified for access from a different
subnet mask. This setting is not necessary when
access is always within the same network. This can
also be set automatically by DHCP.
DHCP OFF This sets whether or not DHCP will be used to
dynamically assign IP addresses, etc. Set this to
ON to have DHCP dynamically assign IP
addresses, etc. Set it to off when a fixed IP address
is used. The IP addresses that are assigned by
DHCP, can be checked by selecting
[CONFIGURATION] - [VIEW SETTINGS] on the
operation panel.
LINK SPEED AUTO This sets the network's communication mode.
“AUTO” is normally selected. During manual setup,
“10 BASE-T FULL”, “10 BASE-T HALF”, “100
BASE-T FULL”, or “100 BASE-T HALF”can be
selected.