Español
Español-5
Figura E.1
Interruptor de desconexión
prolongada
Botón de encendido
Figura C.3
Figura D.1
Figura D.2
Figura C.4
7. Sujete firmemente todos los cables y coloque la tapa de los cables sobre el soporte (
figura D.1
). Para quitar dicha tapa,
levántela como se indica en la
figura D.2
.
8. Conecte un extremo del cable de alimentación a la entrada de corriente alterna en la parte trasera del monitor y el otro
extremo a la toma de corriente.
NOTA:
consulte el apartado Peligro de este manual para asegurarse de que selecciona el cable de alimentación de
corriente alterna adecuado.
9. El interruptor de desconexión prolongada que hay a la izquierda del monitor debe estar encendido. Encienda el monitor y
el ordenador con el botón de encendido (
figura E.1
).
NOTA:
el interruptor de desconexión prolongada es un interruptor tipo on/off (encendido/apagado).
Si este interruptor está en la posición OFF (apagado), el monitor no se puede conectar utilizando el botón frontal.
NO lo conecte/desconecte repetidas veces.
10. Esta función No-touch ajusta automáticamente el monitor con la configuración óptima inicial en la mayoría de cadencias.
Para llevar a cabo otros ajustes, utilice los siguientes controles de OSD:
• Contraste Autom. - Contraste de auto ajuste - (sólo para entradas analógicas)
• Auto ajuste (sólo para entradas analógicas)
Consulte el apartado
Controles
de este manual del usuario si desea obtener una descripción detallada de estos controles OSD.
NOTA:
si surgiera algún problema, consulte el apartado
Solución de problemas
de este manual del usuario.
05_Spain
18/6/07, 10:57 AM
5