CHAPTER 3 INSTALLATION
User’s Manual U13390EJ2V0UM
20
3.2
Clock Settings
3.2.1 Overview of clock settings
The system clocks to be used during debugging can be selected from (1) to (3) below.
(1) Clock that is already mounted on emulation board
(2) Clock that is mounted by user
(3) Pulse input from target system
If the target system includes a clock oscillator, select either
(1) Clock that is already mounted on emulation
board
or
(2) Clock that is mounted by user
. For a clock oscillator, the target device is connected to a resonator
and the target device’s internal oscillator is used. An example of the external circuit is shown in part (a) of Figure 3-2.
During emulation, the oscillator that is mounted on the target system is not used. Instead, the clock that is mounted
on the emulation board which is installed for the IE-78K0S-NS or IE-78K0S-NS-A is used.
If the target system includes an external clock, select
(3) Pulse input from target system
. For an external clock,
a clock signal is supplied from outside of the target device and the target device’s internal oscillator is not used. An
example of the external circuit is shown in part (b) of Figure 3-2.
Caution
The IE system will be hung-up if the system clock is not supplied normally. Moreover, be sure to
input a rectangular wave as the clock from the target. However, it is not necessary to supply a
clock to the X2 pin.
Figure 3-2. External Circuits Used as System Clock Oscillator
(a) Clock oscillator
(b) External clock
X2
X2
Target device
Target device
External
clock
X1
X1
V
SS