2. Procedures after Completion of Installation
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
65
Chapter 1 Installing Operating System
2.2
Confirmation of the ft control software Version
The following describes how to check the version of ft control software.
Confirm the version following the steps below:
Note
Running the following command may fail if the necessary process does not run immediately
after the system startup. In this case, wait for a while (several minutes or so), and try again.
1. Run the following command on the ftSys Management Appliance.
# /opt/ft/bin/ftsmaint –v
ftsys-ftsmaint version 6.7.1-117
The version of the ft control software in operation is displayed.
Make sure that the version is exactly same as those shown above.
This completes the version confirmation.
