![background image](http://html1.mh-extra.com/html/nec/express5800-r320g-e4/express5800-r320g-e4_installation-manual_4205482058.webp)
1. Setup Procedure
Express5800/R320g-E4,
R320g-M4
Installation Guide (VMware)
58
Chapter 1 Installing Operating System
11. When the message below appears, enter "yes" to restart the system. The ESXi host restarts.
A host reboot is required to place these updates into service.
Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]
12. After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from the
drive.
Checking status of ft server
1. After the ftSys Management Appliance restarts, check the duplication status. Confirm that the System
FT LED on the front of the server lights.
2. Run the following command to confirm if the system is running normally.
# /opt/ft/sbin/ft-verify
The results list for each of the configuration is output. If all items show [PASS], it indicates that the
installation has been completed successfully (Output example:).
ftSys Management Appliance hosted by xxx.xxx.xxx.xxx
[PASS]
Host is configured with enough memory
[PASS]
ftSys installed on host
[PASS]
Host software version matches expected version (x.x.x-xxx)
[PASS]
ftSys Management Appliance firewall settings
[PASS]
Host Firmware Boot Type - requires UEFI
[PASS]
Host Legacy memory copy BIOS setting
[PASS]
ftSys Management Appliance installed on boot volume
[PASS]
Multiple paths to storage
[PASS]
Network Configuration
[PASS]
Host ftSys service started
[PASS]
Host logs available after reboot
[PASS]
DNS Configuration
[PASS]
Note
The version displayed in "Host software version matches expected version" above is
different from the version of the ft control software displayed in
"2.2 Confirmation of the ft
control software Version"
of this chapter.
System FT LED