1. System BIOS
Express5800/E120g-M Maintenance Guide
88
Chapter 2 Useful Features
Option Parameter
Descriptions
Thermal Sensor
Disabled
[Enabled]
Enable or disable the thermal sensor
monitoring feature. If this option is set to
Enabled
and when abnormal temperature is
detected, stops POST before OS starts and
waits until the temperature becomes normal.
Check previous System Config
[Disabled]
Enabled
Enable or disable the feature to detect
system configuration change.
If this option is set to
Enabled
and the
system configuration differs from the
previous boot, the system stops before OS
booting and displays confirmation message
whether to continue booting. At this time,
POST pauses until user’s response is made.
BMC IRQ
[Disabled]
IRQ11
Specify whether to allocate interrupt lines for
BMC (Baseboard Management Controller).
Post Error Pause
Disabled
[Enabled]
Enable or disable the feature to suppress OS
booting when POST detects an error, until
user's response is made.
When set to
Disabled
, continues OS booting
regardless of user's response even if an error
is detected during POST.
Memory Error
Halt
[Boot]
Enable or disable the feature to suppress OS
booting when POST detects a memory
degradation error, until user's response is
made. This option is valid only when
POST
Error Pause
is set to
Enabled
. Even if this
option is set to
Boot
, the system stops POST
and suppresses OS boot if all of thememory
resources are degraded.
Power Switch Inhibit
[Disabled]
Enabled
Enable or disable the POWER switch inhibit
feature.
CLI SETUP
[Disabled]
Enabled
Enable or disable the Command Line
Interface SETUP feature. When this option is
set to
Enabled
, the operation of SETUP is
changed to use Command Line Interface
(CLI). To switch back to the menu operation,
set this option to
Disabled
.
For details of the command, run HELP
command after prompt of CLI SETUP is
displayed.
If the number of bootable devices exceeds a
certain number, a message "Failed to get
Boot Variable data" is displayed on command
line, and you are unable to open or change
the Boot menu. Reduce the number of
bootable devices by disconnecting
unnecessary USB device, or change
Option
ROM Scan
of onboard devices or PCI slots
to
Disabled
.
