Reloading Express5800/320Ma Software
4-2
Express5800/320Ma: Software Installation and Configuration Guide
•
Make sure you have the following media available:
– ExpressBuilder CD (1 of 2)
– ExpressBuilder CD (2 of 2)
– Backup media, if you are performing a disaster recovery and can back up the
system, or have a backup from which you can restore data
Reloading Express5800/320Ma Software
1. Do one of the following:
•
Browse to a local network share that contains the contents of the
Express5800/320Ma ExpressBuilder CD (1 of 2). Open the bin folder and
double-click Setup.hta.
•
Insert the Express5800/320Ma ExpressBuilder CD (1 of 2) into the CD-ROM
drive in the enclosure whose power button LED is green-lit.
2. The Express5800/320Ma software reload procedure automatically runs.
If the Express5800/320Ma software reload procedure does not automatically run
when you insert the CD, on the Windows task bar, click Start and then Run.
Substituting the drive letter of your CD-ROM drive for D, type the following
command:
D:\bin\setup.hta
N O T E S
1. If, at any point during the reload procedure, a dialog
box appears with the message
The Target file
exists and is newer than the source
, click
Continue.
2. During the reload procedure, the Progress dialog
boxes may obscure other dialog boxes. If the reload
procedure appears stalled, move the Progress dialog
box and check for a message box that requires you to
click OK.
3. Follow the prompts to run the reload readiness test, which determines whether
your system has the necessary conditions for reinstalling Express5800/320Ma
software. If the system passes the test, go to step
4
.
