NEC Express5800 140He, User Manual

Page: 53 / 398

2-23
„
Suspicion of failure
„ B iod from power-on to operating system start
„
Ap
POST Flow
The flow of o ed by POST is sequentially described below:
IMPORTANT:
Depending on the system configuration, the message "Press Any Key"
eep for many times in the per
pearance of an error message on the display unit
perations execut
requesting key entry may appear on the display screen. This is requested by BIOS
installed optional board. See the explanation described in the manual for the option and on an
press any key.
1.
After pow
memory an
following
the bottom of the screen.
er-on, POST is activated to start memory check. The message indicating the counted size of base
d that of additional memory appears at the upper left corner of the display screen. In addition, the
message appears at
P
OTE:
If you change the factory-default for [Extended RAM Step] in [Advanced] menu
ress <F2> to enter SETUP, <F4> Service Partition, <F12> Network
N
o s the memory test to
b
f BIOS SETUP and execute the memory test, pressing Space allow
e skipped.
It ma
server. Similarly, it may take about a minute to display the proper information on the screen at rebooting.
2.
Detects th
MegaRAI
continued
er keys according to the screen display.
y take several minutes to complete memory check depending on the size of the memory installed in the
e RAID controller built in the server and displays the message prompting the start of the
D Configuration utility (without any key entry for several seconds, POST is automatically
). Press the prop
LS
Co
HA
a
C
C
X
X Logical Drive(s) handled by BIOS
Press <Ctrl><M> or <Enter> to Run Config Utility
Or Press <Ctrl><H> for WebBIOS
Now press
Enter
to start the utility. Do not use
Ctrl
+
M
to start the utility.
For example, the SCSI BIOS setup utility must be used in the following cases:
„
Installation of an SCSI device in the 5.25-inch device bay
„
Connection of an external SCSI device (The removal of the SCSI cable for 5.25-inch device in the server
and the connection of the SCSI cable coming with the server (for external connection) are required.)
„ Modification of SCSI device connections within the server
When the SCSI BIOS setup utility is terminated, the server runs POST from its start again.
When more than one SCSI controller boards are installed on the PCI bus of the server, the messages
indica
g order:
PCI slo PCI #1
and P iority.
I MegaRAID BIOS Version XXX (Build XXX XX XXXX)
pyright(C) 2005 LSI Logic Corp.
-X (Bus XX Dev XX) MegaRAIS SCSI 320-2E
Standard FW XXXX DRAM = 256MB (SDRAM)
B ttery module is present on adapter
hannel-0 ID-14 -- XXX XXXXX
hannel-1 ID-14 -- XXX XXXXX
Logical Drive(s) found on the host adapter.
ting the starts of the SCSI BIOS setup utilities for the installed boards appear in the followin
t number PCI #3, PCI #4, PCI #5, PCI #8, PCI #9, PCI #6, PCI #7, on-board RAID controller,
CI #2. See Chapter 9, List of Optional Devices and their Available Slots for details about boot pr